Hi guys,
Been having so much fun emptying gas tank:). I just installed OFTablet few days ago. But last 2 days ago, I'm stuck on stock looking turbo boost level. And the boost is slow to build. It maxes out on ~8psi actual, and getting there is not fast enough. Target is 16-17psi. I hooked up INPA laptop and 2AAF(fuel pump plausibility) and 30FF(under boost). I had recently replaced HPFP recently.
It used to be that Actual boost was more livelier than Target boost before this gremlin took over.
No SES or rough vibrating engine or warning lights though. It drives a little slower than stock now. I switched to different OTS maps but to no avail. I reset and cleared adaptation values too, and no help.
Did I blew open a vacuum hose? I checked them on the solenoids general area. Put my finger on the top hoses and the canisters for vacuum and they suck in like it should. I can also see 2nd wastegate arm moving when I plug the both hose/canister holes. Can't see the 1st w/g moving since it's behind all the stuff.
The previously mentioned 2 errors appear 1-2 frequency during like 1 hour of street driving. So not too often.
I want to trace the vacuum hoses, esp, the one that disappears back side of the engine.
Any help is appreciated. I gooooot to get it back online...
Been having so much fun emptying gas tank:). I just installed OFTablet few days ago. But last 2 days ago, I'm stuck on stock looking turbo boost level. And the boost is slow to build. It maxes out on ~8psi actual, and getting there is not fast enough. Target is 16-17psi. I hooked up INPA laptop and 2AAF(fuel pump plausibility) and 30FF(under boost). I had recently replaced HPFP recently.
It used to be that Actual boost was more livelier than Target boost before this gremlin took over.
No SES or rough vibrating engine or warning lights though. It drives a little slower than stock now. I switched to different OTS maps but to no avail. I reset and cleared adaptation values too, and no help.
Did I blew open a vacuum hose? I checked them on the solenoids general area. Put my finger on the top hoses and the canisters for vacuum and they suck in like it should. I can also see 2nd wastegate arm moving when I plug the both hose/canister holes. Can't see the 1st w/g moving since it's behind all the stuff.
The previously mentioned 2 errors appear 1-2 frequency during like 1 hour of street driving. So not too often.
I want to trace the vacuum hoses, esp, the one that disappears back side of the engine.
Any help is appreciated. I gooooot to get it back online...
0 commentaires:
Enregistrer un commentaire